Notes

• The apparatus includes a 25 mL buret and a 125 mL flask. After selection of the parameters, the buret is filled with titrant to a random level just below the zero mark, and the flask is loaded with a 25 mL aliquot.
• To begin, select the acid, the base, their concentrations, which of them is in the burette, and choose an indicator. Then click "Add solutions...".
• Click on the burette stopcock to start, pause or stop the titration. (The titration will stop automatically at the 25 mL mark if it is not stopped earlier.)
• Any parameter or parameters can be changed after the first have been chosen. Click "Add solutions..." again to begin a new titration.
  
• Check "Show the equivalence point" to see and compare the equivalence point to the end point.
• Use the scroll bar to adjust the dropping rate.
• Click in the graph area to clear it. (Changing any of the parameters will clear it anyway.)

Note: The method used to calculate the pH and generate the curves is the same as that in the text, though the full the quadratic solution is always used, that is, the "usual approximation" is not applied. However, the contribution to [H⁺] from the auto-ionization of water is ignored (as it is in the text). For very dilute solutions and/or very weak acids or bases, this leads to a discontinuity in the curve near the equivalence point which would not be seen in a real experimental plot.